Pianos consistently make movers yearly list of products that are most regularly damaged. Grand pianos are especially problematic. Practicing the following treatments for dismantling, padding and packing grand pianos will prevent damage, lower claims expense, and enhance client complete satisfaction.
1) A minimum of 3 people are needed to manage an infant grand piano. If the infant grand piano requires to go up or down stairs or if a complete or performance grand piano requires to be transported, a minimum of 4 individuals are required.
2) Always finish a accurate and thorough stock. It may be preferable or needed to use a visual stock to adequately explain and show pre-existing damage.
3) As various parts are dismantled, please place all hardware in an appropriately labeled parts bag and then position the parts bag in a "Components Box".
4) Remove the music rack (lyre) from its track by pulling it towards the keyboard. Wrap it in a tidy furniture pad.
5) Disconnect the lid by getting rid of the hinge pins. Wrap the cover in a tidy furnishings pad.
6) Get rid of the prop that holds the cover open and cover it in a clean furniture pad. The prop has a hinge pin and is in two pieces.
7) Remove the pedal assembly and cover it in a clean furnishings pad. When eliminating the screws, please be careful not to drop the braces. As you deal with the piano, number the push-rods from left to right as "1", "2", and "3", by putting a piece of masking tape with the appropriate number on each rod.
8) Pad the piano by putting a clean rolled furniture pad (stretch-wrap the pad to avoid it from unrolling) on the cover of the keyboard to avoid it from flopping open while you deal with the piano. Keep in mind: Please ensure that the surface of the piano is dust-free prior to padding it.
9) Position a piano board and attach the straps so that it is all set to get the piano. The raised brace on the piano board should be at the keyboard end of the piano.
10) Eliminate the left front leg by placing someone underneath the piano at the left end of the keyboard. The other 2 individuals should support the left front corner. The person underneath the piano should turn the keeping block so that the long end points far from the leg. The screws, if there are any, should then be eliminated. The "beneath" individual must then extricate the piano prior to really removing the leg. Make sure to have two people lifting the corner of the piano while the third individual gets rid of the leg. Note: Please be sure to keep in mind which legs were gotten rid of from which positions given that some pianos have legs that are not interchangeable.
11) Place the piano on the piano board by reducing the "leg-less" end onto the board. Please be sure to raise the whole piano somewhat while finishing this maneuver to avoid undue pressure on the staying, attached legs as the piano pointers. Be sure that the piano is centered comfortably versus the brace at the end of see it here the piano board.
12) Get rid of the two remaining legs and wrap them in tidy furniture pads. These legs are kept in location by a "crucial and slot" arrangement. To remove the leg, slide it inward toward the center of the piano up until it comes out of the slot.
13) Secure the piano to the piano board by bringing completions of the straps together and fastening them. Place folded burlap pads over the furniture pads but under the straps to provide additional protection to the edges of the piano. To prevent the strap near the narrow end of the piano from slipping off, tie the loose ends of the two straps together.
14) To move the piano over a flat, level surface, tilt the piano and piano board and place a four-wheel dolly under the center of the piano board.
15) To move the piano up or down stairs, use the piano board as a skid. After sufficiently padding the stairs for defense versus house damage, put the keyboard end of the piano toward the bottom of the stairs. Connect a bulge strap to the top end of the piano board to prevent the piano from a fantastic read slipping.
16) To fill the piano, leave it on the piano board and location it in a tier as the very first base item with the keyboard dealing with the wall of the preceding tier. The finest place to load the cushioned cover is between the piano and the preceding tier or in between the wall and the piano.
Grand pianos represent a significant obstacle, they can be moved without damage by utilizing common sense and practicing check these guys out the procedures noted above.